Abstract
For the purpose of enhancing the solder joint reliability of a wafer level chip scaling package (WLCSP), the WLCSP adopted the familiar design structure where both the stress compliant layer with low elastic modulus and the dummy solder joints are considered as structural supports. However, the predicted fatigue life of the solder joints at the internal part of the packaging structure using the conventional procedures of finite element simulation are higher than under actual conditions as a result of the perfect bonding assumption in the modeling. In this research, in order to improve the thermomechanical reliability of the solder joints, a node tie-release crack prediction technique, based on non-linear finite element analysis (FEA), is developed and compared with the estimation of the solder joint reliability using conventional methodology. The predicted results of reliability, using the novel prediction technique, show a lower fatigue life of the solder joint than that when using conventional one when the fracture regions in the dummy solder joints are simulated under quasi-steady state. At the same time, the result of the thermal cycling test also shows good agreement with the simulated result when using the proposed node tie-release crack prediction analysis. Copyright © 2005 by ASME.