Abstract
In this study, a system to recover waste heat comprised several thermoelectric generators (TEGs) to convert heat to electrical energy has been constructed. TEG modules are attached to the exhaust pipe of an automobile and furnace wall respectively to test and verufy the feasibility of waste heat recovery applications. Simulations and experiments for the thermoelectric module in this specific system were undertaken to assess the practicability of these applications. In order to estimate the temperature difference between thermoelectric elements, a thermal resistor network has been constructed. The results assist in modifying the actual temperature difference across the P- and N- couple. During simulations, heat sinks configurations and thermal field distributions are discussed, which helps to optimize the system design. Somehow, it is well known that the thermal contact effect dominates the thermoelectric properties, such as the power factor, ZT etc. Therefore, applying a suitable clamping pressure to reduce thermal contact effect is necessary. Finally, the concept of “effective Seebeck coefficient” has been proposed. This proposed value is a very important indicator which is expressing the behavior of the TEG module operating in the actual conditions we provided, and it can be used to predict the performance of the TEG module under any other condition. Throughout these simulations and experiments, the discussions of power generated with commercial TEG modules are presented. The results establish the feasibility of waste heat harvesting applications.