Abstract
A new process for producing rapidly solidified bulk alloys was developed based on the hammer-and-anvil concept. In the process, an Al-12 wt pct Si alloy slab was built up layer by layer and then hot worked to get a solid and integral sheet. The oxygen content of the layer-deposited alloy is less than the typical value of powder metallurgy (PM) alloys by one order, and the cooling rate can reach 10 4 K/s, which is higher than that of the spray deposition process. In comparison with the ingot-processed Al-12 wt pct Si alloy, layer-deposited alloy exhibits superior mechanical properties. This is attributable to the fine and uniform silicon-particle distribution which not only brings on dispersion hardening effect but also raises the elongation and fracture strain. The mechanisms responsible for this enhancement were discussed in terms of particle size and effective volume fraction.