Abstract
Electronic delay has been a critical problem in active noise control (ANC) systems. This is true whether a feedforward structure or a feedback structure is adopted. In particular, excessive delays would create a causality problem in a feedforward ANC system of a finite-length duct. This paper suggests a multirate signal-processing approach for minimizing the electronic delay in the control loop. In this approach, digital controllers are required in decimation and interpolation of discrete-time signals. The computation efficiency is further enhanced by a polyphase method, where the phases of low-pass finite impulse response (FIR) filters must be carefully designed to avoid unnecessary delays. Frequency domain optimization procedures based on H 1 , H 2 , and H ∞ norms, respectively, are utilized in the FIR filter design. The proposed method was implemented by using a floating-point digital signal processor. Experimental results showed that the multirate approach remains effective for suppressing a broadband (200-600 Hz) noise in a duct with a minimum upstream measurement microphone placement of 20 cm. © 2002 Acoustical Society, of America.