Logo image
返回
The ATLAS semiconductor tracker end-cap module
期刊文章   同儕審查

The ATLAS semiconductor tracker end-cap module

A. Abdesselam, P.J. Adkin, P.P. Allport, J. Alonso, L. Andricek, F. Anghinolfi, A.A. Antonov, R.J. Apsimon, T. Atkinson, L.E. Batchelor, …
Nuclear Instruments and Methods in Physics Research, Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 卷.575(3), 頁碼.353-389
06/2007
DOI: https://doi.org/10.1016/j.nima.2007.02.019

摘要

ATLAS LHC Microstrip Module SCT Silicon Nuclear and High Energy Physics Instrumentation
The challenges for the tracking detector systems at the LHC are unprecedented in terms of the number of channels, the required read-out speed and the expected radiation levels. The ATLAS Semiconductor Tracker (SCT) end-caps have a total of about 3 million electronics channels each reading out every 25 ns into its own on-chip 3.3 μ s buffer. The highest anticipated dose after 10 years operation is 1.4 × 10 14 cm - 2 in units of 1 MeV neutron equivalent (assuming the damage factors scale with the non-ionising energy loss). The forward tracker has 1976 double-sided modules, mostly of area ∼ 70 cm 2 , each having 2 × 768 strips read out by six ASICs per side. The requirement to achieve an average perpendicular radiation length of 1.5% X 0 , while coping with up to 7 W dissipation per module (after irradiation), leads to stringent constraints on the thermal design. The additional requirement of 1500 e - equivalent noise charge (ENC) rising to only 1800 e - ENC after irradiation, provides stringent design constraints on both the high-density Cu/Polyimide flex read-out circuit and the ABCD3TA read-out ASICs. Finally, the accuracy of module assembly must not compromise the 16 μ m (r φ) resolution perpendicular to the strip directions or 580 μ m radial resolution coming from the 40 mrad front-back stereo angle. A total of 2210 modules were built to the tight tolerances and specifications required for the SCT. This was 234 more than the 1976 required and represents a yield of 93%. The component flow was at times tight, but the module production rate of 40-50 per week was maintained despite this. The distributed production was not found to be a major logistical problem and it allowed additional flexibility to take advantage of where the effort was available, including any spare capacity, for building the end-cap modules. The collaboration that produced the ATLAS SCT end-cap modules kept in close contact at all times so that the effects of shortages or stoppages at different sites could be rapidly resolved. © 2007 Elsevier B.V. All rights reserved.

相關連結

指標

1 檢視次數

詳細資料

Logo image