Abstract
The eutectic Sn-Ag solder alloy is one of the candidates for the Pb-free solder, and Sn-Pb solder alloys are still widely used in today's electronic packages. In this study, the interfacial reaction in the eutectic Sn-Ag and Sn-Pb solder joints was investigated with an assembly of a solder/Ni/Cu/Ti/Si 3 N 3 /Si multi-layer structures. In the Sn-3.5Ag solder joints reflowed at 260°C, only the (Ni 1-x ,Cu x ) 3 Sn 4 intermetallic compound (IMC) formed at the solder/Ni interface. For the Sn-37Pb solder reflowed at 225°C for one to ten cycles, only the (Ni 1-x ,Cu x ) 3 Sn 4 IMC formed between the solder and the Ni/Cu under-bump metallization (UBM). Nevertheless, the (Cu 1-y ,Ni y ) 6 Sn 5 IMC was observed in joints reflowed at 245°C after five cycles and at 265°C after three cycles. With the aid of microstructure evolution, quantitative analysis, and elemental distribution between the solder and Ni/Cu UBM, it was revealed that Cu content in the solder near the solder/IMC interface played an important role in the formation of the (Cu 1-y ,Ni y ) 6 Sn 5 IMC. In addition, the diffusion behavior of Cu in eutectic Sn-Ag and Sn-Pb solders with the Ni/Cu UBM were probed and discussed. The atomic flux of Cu diffused through Ni was evaluated by detailed quantitative analysis in an electron probe microanalyzer (EPMA). During reflow, the atomic flux of Cu was on the order of 10 16 -10 17 atoms/cm 2 sec in both the eutectic Sn-Ag and Sn-Pb systems.