Abstract
The eutectic SnBi solder alloy is a candidate for Pb-free replacement of the conventional eutectic SnPb solders. This study presents series of results on the binary eutectic SnBi and ternary SnBi-1 wt% Cu a solder joints. Compositional analysis and wettability of the as-fabricated solder alloys are reported. In addition, microstructure, adhesion strength, fracture surface and contact resistance of the solder joints are also evaluated. The results of the wetting balance show that the addition of 1 wt% Cu has little effect on the contact angle of the eutectic SnBi solder alloy with various metallization layers. The adhesion strength of solder joints degrades abruptly after 2000 thermal cycles. In addition, thermal cycling would result in cracking in the solder joints, which is due to the mismatch in thermal expansion coefficients. Portions of the thermal fatigue cracks nucleate at the edge of the solder fillet, and then propagate along the solder/conductor interface. Some cracks are, however, through the Al <sub>2</sub> O <sub>3</sub> substrate. The contact resistance of the solder/Cu joint does not increase after thermal cycling since the resistivity of Cu <sub>6</sub> Sn <sub>5</sub> is lower than that of the solder. The solder joints of 42Sn-58Bi/Cu, SnBi-1Cu/Cu, 42Sn-58Bi/PtAg, and SnBi-1Cu/PtAg assemblies maintain their integrity after 2000 thermal cycles since the increase in contact resistance is rather small (ΔR<0.5 mΩ).